| jdmbo1 |
I connected the white wire from the pac module to the pin#3(green/red) of the car connector. I also connected the brown and white wire to the radio harness. I'm unable to program the unit after doing this. I was able program the version number, which is 3. After I turn the car onto ACC, the light from the PAC will blink 3 times, but will not stay lit. According to the instructions, it stays lit, and I would have 7 seconds to program the buttons, but the LED turns off after the initial 3 blinks to indicate the version number. I read the note and it says that on some models, a 3900 or a 5100 ohm resistor. Could this be a problem. Has anyone installed the ECL2 or the ECL into an eclipse unit and got it to work successfully?
PS I'll post pictures once I get everything installed. |
|
|
| jdmbo1 |
http://www.pac-audio.com/swixprogra...Vehicles&ID=421
I think I might have found the problem, I connected the black ground wire from the interface to the black ground wire in the harness, which is pin 20, I'm guessing I have to connect that to pin 11 brown instead? Can someone who has done this install tell me if thats right? |
|
|
|
